Why does not AC excitation use in rotor of AC Generator
instead of DC excitation?
- 2 Answers
- 5639 Views
- A2Z Group, I also Faced
- E-Mail Answers
Answer Posted / deepak mishra
actually in rotor of ac generator we require fixed
alternate north and south pole for generation of ac, theese
are electomagnet.theese poles are acheived by direct
current bcz in case of ac pole changes there polarity in
each half cycle.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
how to select size of hardware for linking aluminium busbar is it depend on area of busbar or current flowing through bus bar
What is Harmonics how it is produced and what is the method to control the same
is there any phase difference occurs while primary and secondary side mutual induction occurs?
1) why a dg set shows variation of power factor and load when synchronised with other dgs? 2)Why the load sharing is not become equal in all dgs?. 3)When a dg set will not run on auto start?
How to test Alternator stability test for REF relay
What is an alternator impedance value?
what happend to DC shunt motor if its field winding insulation becomes slightly weak? will that motor can run on full load or not explain in detail. thanks
If i have two 3000 kW motors and the whole facility requires a 10 MVA transformer. What would be better installing two 5 MVA transformers(one for 1 motor ) or just a single 10 MVA transformer for both of them. Give reasons for your answer.
What is kvar?
Why saturation region slowly shifted in the left side?
how is working bearing heater?
Why open circuit test of transformers is conducted at rated voltage??Why not any other voltage??
What is current & voltage ? Voltage perform at any load without current or not?
WHAT IS AIR GAP VALUE IN MM FOR A 11KV BUSHING OF 11KV/440V DISTRIBUTION TRANSFORMER. AND AIR GAP VALUE OF 25 KV BUSHING OF AT TRANSFORMER OF 25 KV TRACTION. WHAT IS THE CALCULATION FOR THE AIR GAP PERMITTED FOR BUSHINGS AT DIFFERENT VOLTAGES.
Does outdoor isolator loose connection cause short circuit current in that circuit? if yes then how ??
