what is meant by Is limiter?what is the use of current
limiters in electrical ditribution network?

Answers were Sorted based on User's Feedback



what is meant by Is limiter?what is the use of current limiters in electrical ditribution network?..

Answer / shibu joseph

Is-limiter is a device for limiting the short circuit. This is a fast acting device and interrupts the short circuit typically in less than 3 m sec. This protects the other circuit breakers in the network with lower short circuit breaking current capability

Is This Answer Correct ?    7 Yes 0 No

what is meant by Is limiter?what is the use of current limiters in electrical ditribution network?..

Answer / manikandan iiet student

Is limiter is nothing but a starting current or supplied
current limiter, which is used to limit the starting current
flow through the circuit to avoid the harmful effect in that
like starters, circuit breakers, fuse etc.

Is This Answer Correct ?    5 Yes 4 No

Post New Answer

More Electrical Engineering Interview Questions

why an ac solenoid valve attract the plunger eventhough we interchanges the terminal?will the ploes changes?

1 Answers  


What is the maximum allowed kwa through 2.5mm cable. Electric company installed 2 electric meter at my premises . Two jumper wires of 2.5 mm are used to connect . 2 single phase meters with allowable load 6 and 3 kwa. These jumper wires are taken from a 3 phase electric meter. Meters are in open Sun. What max load these wires can take.

0 Answers   KESC,


what will happen if frequency is below 50 hz?

0 Answers   Student,


Why we use a shunt capacitor or synchronizing Motor To Improve a Power factor pls reply me in this mail dinesh_elect_eng@yahoo.com

4 Answers  


how can a transformer test by megger?

1 Answers  






What is the function of probe in cro?

0 Answers  


what is thermal setting and magnetical setting?

1 Answers  


If the characteristic Impedance is equal to load Impedance then…… a) voltage will be increased b) power transmission is zero c) …… d) max. power is transmission to load

2 Answers  


what is the maximum current carrying capacity of a 95 sqmm cupper under ground cable laid partialy in land and partialy in ground?

4 Answers  


in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?

0 Answers  


What is ramp signal?

0 Answers  


What is meaning of star delta connection / delta star connection and which one is best and what is the advantage?

0 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)