Answer / bhatt satish

.8lagging

Answer / guru

It should be not less than 0.85 Lag

Answer / sunil

0.8 lagging and 0.8 lagging only. It is mandatory to have
this pf in DGs.

Answer / mohit

It will depend upon load connected to DG.

Answer / vijay balu raskar

Yes, power factor is 0.85 lagging or more than this. Also, based on operating loads.Because, power factor is the ratio of active power to the appearant power.

Answer / ram khapekar

0.98 lagging

what happens if we earth negative electrode of an rectifier transformer used in ESP. In which normaly positive is earthd from inside the xmer.

1 Answers  

why we avoid parallel operation of diesl generator?

4 Answers  

What the methode get earth resistance?

2 Answers  

why co incidence factor considered in transformer sizing?

0 Answers  

why 3phase is 440v but where as we get phase voltage 220v,we have to get 220*3=660v.can u pleas give in detailed

3 Answers   Avantha Group,

wht is an AVO metre. and whre it is used?

1 Answers   Mayflower,

Is RTCC panel needs any control supply.

0 Answers   HPCL, Schneider,

why the power factor of the induction motor is low?

1 Answers  

Three phase power is measured with two wattmeeter for balance three phase load.the reading of one wattmeter is zero.we can conclude that the power factor of balance load is?

1 Answers  

why do we prefer a 3-phase delta connected load rather than star connected?

4 Answers  

why dc moter are not earthed ????

2 Answers  

WHAT IS THE DIFFERENCE BETWEEN VOLTage and potential diff

5 Answers