Answer / aajinkya

Generally 300 square mm conductor is used in case of 33kv line

Answer / ajit g. k.

How can you find out the cable size without knowing the
load requirements, the current that is to flow through it.
And also, a line can never be 33kV and 11kV at the same
time. A 11kV line becomes a 33kV line when it passes
through a transformer(just for info). The cable sizes
differ as the current flow is different.even the conductors
change. In transmission lines that carry current say, 1000A
in 11 kV, its about 334A in 33kV line which follows. The
cable used is XLPE in 11kV and in 33kV we use AAA
conductors. sizes stil depend on many other factors too.

Answer / sudheer

generally used 40mm size

Answer / eengineer

300 mm

Answer / vasu

0.2*20cm

If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?

0 Answers  

In a three-phase full converter, every SCR conducts for a.60deg. b. 120deg. C.180deg. d.90deg

3 Answers  

we have total 1000hp motors we paid 7 laks rupees how to reduce power bill

4 Answers  

i need to calculate high voltage line power factor daily basics but there is meter reading kwh and kvah while calculating power factor kwh/kvah formula was right. for examble there is point c=13kwh c=1.8 lag c=1.2 lead and c=14.5kvah like that i know that p.f =kwh/kvah but c=1.8lag kvarh and c=1.2lead kvarh points i dont know if u know please reply

1 Answers  

What is the difference between PS & metering CT (5p20,0.5 etc.)? Why in PS class CT only Vk is given ? Is PS class CT is more accurate than metering CT?

0 Answers  

what is the highest transmission voltage in india???

49 Answers   Bhel, EIPL, Engineering, Jindal,

what is compatible kva for 3300 watts and why

1 Answers   FoodBev,

What is ST and specify its range of voltage.

0 Answers  

Why a Permanent Magnet Generator has higher frequency as compared to frequency of main alternator?

0 Answers  

why is it that the HT motors & motors having very low kW rating(<1kW) have windings connected in STAR, whereas the motors having in between kW ratings have DELTA connected windings??

5 Answers  

What are the main factors to be considered(In terms of energy conservation) while selecting a new air compressor?

1 Answers  

how to calculate magnetic force genrated by a coil ?

0 Answers   L&T,