What is the rating of your substation and what are the
different types of substations?
Answers were Sorted based on User's Feedback
Answer / rajendran.m
660KV/440KV/220KV/110KV/66KV/33KV/22KV/11KV/440V.
Two typs of substations.
1. Indoor substation
2. outdoor substation
Is This Answer Correct ? | 66 Yes | 13 No |
Answer / raj kumar hora
600kv/400kv/220kv/132kv/33kv/11kv/6.6kv/415v
2 types of sub-station
a.outdoor type
b.indoor type,upto 33kv only.
Is This Answer Correct ? | 31 Yes | 9 No |
Answer / tarun aggarwak ymca
765kV, 400kV,220kV,132kV , 66kV,33kV,11kV
The substations can be classified in several ways including the
following:
i) Classification based on voltage levels e.g.:
AC Substation: EHV, HV, MV), LV;
HVDC substation
ii) Classification-outdoor or indoor.
Outdoor substation is under open sky. Indoor substation is
inside a building.
iii) Classification based on configuration, e.g.:
a) Conventional air insulated outdoor substation or
b) SF6 Gas Insulated Substation (GIS)
c) Composite substations having combination of the above two.
iv) Classification based on application.
a) Distribution substation
b) Switchyard in Generating Station
c) Switching substation (without power transformers)
d) Sending-end substation
e) Receiving substation
f) Factory substation
g) Compensating substation e.g. having static var compensation etc.
h) Load substation, e.g. arc-furnace substation.
Is This Answer Correct ? | 25 Yes | 6 No |
Answer / pillay
It is a 5 MVA 11KV/433 VOLT INDOOR SUBSTATION.
A) Indoor substation
B) Outdoor substation
C) Compact substation
Is This Answer Correct ? | 11 Yes | 17 No |
Answer / sachin
1)- generating
2)- transmission
3)- distribution
Is This Answer Correct ? | 1 Yes | 7 No |
what do you mean by leading power factor & lagging power factor
what is AH of battery
What is the resonant peak?
Why nutral wir used thinner than phase wire
Given a collection of points P in the plane, a 1-set is a point in P that can be separated from the rest by a line; i.e. the point lies on one side of the line while the others lie on the other side. The number of 1-sets of P is denoted by n1(P). The maximum value of n1(P) over all configurations P of 19 points in the plane is 18
HOW TO CALCULATE HV TEST VOLTAGE FOR ELECTRICAL EQPT.
What is Earthing?
how to find out difference between ELCB, MCB and RCB on looking on it
To attain a powerfactor more than .95, how much kvr should we use for 100 HP of current
4 Answers Bhel, Scooters India,
why cont we short earth and N.......?
how to calculate busbar size? if ex:1000amps i need to calculate busbar size and what size of bar?if any example caculation pls give the formulas.
1- XC and the RC time constant are both measures of the reaction of C to a change in ____? 2-The power factor is a numerical ratio with a value between 0 and 1 equal to the ______________ of the phase angle. 3-When V and I are out of phase because of reactance, the product of V times I is called ______________ power 4-For _____________ inductors, the branch currents can be added algebraically. 5- The ______________ power in watts can be calculated as I^2R 6-Calculate XL with L = 30mH and f = 1kHz ( I have Xl=2piFL 2*3.141592653*1kHz*30mH =188 ohms Please check) 7-A parallel RL circuit has the values, R = 5kohms, XL = 5kohms. A voltage source of Vt = 10Vrms is connected in parallel to R and L. Determine the total current, It delivered by the voltage source Vt. 8-A series RC circuit has R = 1Mohm and C = 1microF. How long would it take for the capacitor to fully discharge if it is initially fully charged? 9-A circuit has real power = 300W and an apparent power of 500VA. Determine the power factor and phase angle. 10-The time constant for an LR series circuit is T = 0.1s and R = 10ohms. Calculate the inductance L.