Interested to Buy Any Domain ? << Click Here >> for more details...
what is the conductor size in 33/11 kv line
- 5 Answers
- 24865 Views
- Al-Thamer, I also Faced
- E-Mail Answers
Answer Posted / ajit g. k.
How can you find out the cable size without knowing the
load requirements, the current that is to flow through it.
And also, a line can never be 33kV and 11kV at the same
time. A 11kV line becomes a 33kV line when it passes
through a transformer(just for info). The cable sizes
differ as the current flow is different.even the conductors
change. In transmission lines that carry current say, 1000A
in 11 kV, its about 334A in 33kV line which follows. The
cable used is XLPE in 11kV and in 33kV we use AAA
conductors. sizes stil depend on many other factors too.
| Is This Answer Correct ? | 14 Yes | 9 No |
Post New Answer View All Answers
Fantio of tranformer
in Telecom DC system-why positive +ve is made earthed.and - ve is fed to load.
How to test the Secure Elite 440 Multi function meter working condition.
Is any AC drive(VFD) had a feature of DC injection braking? if available please mention the detail. i.e drive can supply braking torque when the motor in idle state.
Given a collection of points P in the plane, a 1-set is a point in P that can be separated from the rest by a line; i.e. the point lies on one side of the line while the others lie on the other side. The number of 1-sets of P is denoted by n1(P). The maximum value of n1(P) over all configurations P of 19 points in the plane is 18
What is difference and reason b/w -48V BTS system and 24 V BTS system. Plzzzzzzzzz tel me.
What is power relay?
what is the necessity of under ground cables ??
To make a basic instrumentation amplifier, it takes A One op-amp with a certain feedback arrangement B Two op-amp and seven resistors C Three op-amps and seven capacitors D Three op-amps and seven resistors
what is the difference between fault current ant short circuit current?
What is polar plot?
what is the preventive maintence for ht panels and busbars and vcb abd acb's.
I have a small system with two motors that are running on 380 vac, 60 hz. These motors are expensive and I usally get them from Brazil. I am adding another motor to the system, but I want to purchase a 480 vac, 60 hz motor to use. It will be on a VFD that is rated fro 380 thru 480. Is this posible and will I have to use a larger motor and derate it?
What will happen if i used 11KV earth ht kit to 11 KV / 11 KV cable termination?
WHAT IS IM (INDEX OF MOUNTING )IN MOTORS
