Answer / m.srinivasa reddy

at the time of putting the plug top in plug point first earth pin touches the earth pin.any leakage is there then it will goes to the earth. then it will be safety for us and we can save human.

Answer / kundanmalani1990

they are depend to the r=row L\A mean the resister are
increase so the cross area are the decrees mean resi are
inversely proportional to the cross section of area ... and
so the resi are to the high so the plug point is the bigger
to compere to the two pin

Answer / dhivyabharathi

The earth pin has to send fault current to earth.so, the
resistance of that path should be low.to get low resitance,
cross sectional area should be more. it can be understood
from R=pl/A.so the cross sectional area of tat pin should be
high.

Answer / k.mathivanan

To terminate the static energy from the high power units,

Answer / siva

I. we can differancate the Earth pin form other pins then
in Earn Pin Is Bigger to avoid melting during the short
circuit current ,overheat , then human safety

Answer / meenakshi

Reason of earth Pin larger in diameter than other pins in a
plug socket :-
Accidently also one can not insert earth pin in other
pins .
the above feature is for foolfroop safety & no other
reason like low restance etc

Answer / akshita

R= raw*L/A

so resistance is directly proportional to the length and resistivity.
human body resistance is law and always current choose law resistance4 path that's for earth pin is big for choosing a law resistance path for the current

how can i apilly for electrical c licencese.sir,i completed B.Tech in electrical & electronics engineering in 201onot working any company

0 Answers   Subros,

what is lxr?

0 Answers   NTPC,

do we people experience any shock if we catch any one of the three phases (R Y B)in air with out touching ground.

7 Answers  

If two transformers same rating(11KV / 440V)connected in the same primary line(11KV), can we connect(bus coupler) secondary side directly or need a synchronization????

3 Answers  

why conductors of low tensile strength 1)produce greater sag and 2)can not be used for larger spans

1 Answers  

how to combine two linear transformers...............

1 Answers  

DEAR SIR/MADAM,CLEARLY EXPLAIN ABOUT CRAWLING AND COGGING EFFECTS IN INDUCTION MOTOR.

0 Answers   Greenko Group,

what should we do when the CT secodary gets open? how do we short circuit it? using tester or screw driver? not dangerous?

6 Answers  

Star & delta kis principale pa hai.

3 Answers   ME,

what is the MF if CT ratio is 500/5 and in meter specification is 3.75 REVS/KWH? Thanks and Regards Selvendran.N

1 Answers  

WORKING PRINCIPLE OF VACCUM CKT BREAKER ?

2 Answers  

Give idea about General Engineering. From which book i can study this topic. Pl. reply me via email. My email is ravi@bhelhwr.co.in, also give the name of book/website, from where i can prepare it.

0 Answers   TATA,