How to calculate the sag of OPGW during stringing???
No Answer is Posted For this Question
Be the First to Post Answer
How would you relate your key competencies to this position?
What are the causes of having an rmu explode after installation? And how do u treat the bushings of an rmu?
WHY IS THE EARTH FAULT CURRENT ALWAYS LESS THAN THE NORMAL CURRENT??
1)What is a Triode? What are its uses? 2) What is a Triac? 3) What is a Thyristor?
why do we need a 4th wire in 3phase 3wire transmission line
wat s reactive power.... how could it be compensated.....
How do you think they do earthing or grounding in ships and aeroplanes?
Define the overload capacity of the motor.
A 3PH MOTOR RUNNING IN NORMAL CONDITION AND ITS AMPERE ALSO UNDER ITS FULL LOAD CURRENT,ITS CABLE RATINGS ALSO HIGER THN ITS CAPACITY,BUT ITS CABLE GETTING ABNORMAL HEAT(NOT TOO HOT)WHY ITS GETTING HOT LIK THIS?
How many types of protection relays are there based on the characteristic?
what is HVDC, what are advantages over conventional system?
if receiving voltage is higher than sending ones what will be the effect of receiver
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)