Interested to Buy Any Domain ? << Click Here >> for more details...
Three way plug point is there ,in that plug why we need
earth pin is bigger than compare with phase and nutral pins?
- 7 Answers
- 10612 Views
- IIT, I also Faced
- E-Mail Answers
Answer Posted / k.mathivanan
To terminate the static energy from the high power units,
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what is meant by re-rolling motor? how it differs from standard motor?
can I improve the furnace power factor (10 mva transformer) by adding a capacitor bank before the transformer.Does system power factor vary a lot with the furnace PF?
Can double compression glands be used with regular cables?
what is mean by drives?
Can we use BS 6651 and BS EN 62305 standards for computer room lightning ptotection in substation?
How to calculate fault level of 11 KV system
What is A check, B check, C Check & D check for a diesel Generat
33kv Rated output avilable in market (any where in india)
how to calculate
What is meant by Low Resistance Cable and High Resistance Cable.
Why MCCB is Getting tripped sometimes when there is no load in the Midnight ?
what is meant by impedance & transient protection?
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
how to calculate the magnetizing current of ct ( 800A/1A) for Relay 64
In TNC switch, is there any 1NO+1NC block ? and if we move over closing position, is ther any affect on trip position or vice versa?
