wat is power factor
Answers were Sorted based on User's Feedback
power factor is tghe ratio between Active power and apearant power
PF=KW(actvie power)/KVA(appearant power)
Is This Answer Correct ? | 27 Yes | 0 No |
Answer / hema chandra.m
power factor is the cosine angle of the voltage and current
Is This Answer Correct ? | 18 Yes | 7 No |
Answer / kalyan
Power Factor is the numerical value of the cosine of the
phase angle between the applied Voltage and the Current
drawn from the applied Voltage.
Is This Answer Correct ? | 7 Yes | 2 No |
Answer / abhay
we know p=vi cos¤ where cos¤ is called
power factor
oterwise pf is also equal to =r/z
Is This Answer Correct ? | 2 Yes | 0 No |
Answer / thanigai1984
power factor is the ratio between Active power and apearant
power
PF=KW(actvie power)/KVA(appearant power)
we used to improve the power factor by change the phase
shifter.... and the capacitor banks
Is This Answer Correct ? | 2 Yes | 0 No |
Answer / eraks
wenever v supply power (S) to a load den it gets divided into two parts namely active/real/true power (P) and reactive power(Q) depending on the type of load.
so v can say S= P+Q vectorially &
P = S cos#
Q = S sin#
where S is supply power or apparent power.
=> cos# = P/S i.e. ratio of true power and apparent power.THIS is POWER FACTOR.
Its value lies btwn (-1) to ( +1)
power factor is negative wen direction of flow of power
gets reversed i.e. from load to supply or v can say it may b the case due to ferranti effect.
Is This Answer Correct ? | 1 Yes | 0 No |
Answer / lakshman raju
the ratio of the real power flowing to the load to the apparent power and its value lies between 0 to 1.
Is This Answer Correct ? | 2 Yes | 2 No |
My load is 1635 KW. & current pf is 0.884, I have to improve it for 0.99.Please suggest what KVAR value is needed?
What is static frequency control used in gas turbines
How many sprinklers should be in one pipe line?
what is ceiling voltage in an exciter?
1 Answers KEPCO Energy Service Company,
how we are desining 63.5 ohm resistor for NGR of alternator?
Can I use less voltage cable for neutral, since the voltage of return path is zero ideally?
How can step up and step down process in power transformer
1 Answers MSETCL Maharashtra State Electricity Transmission Co Ltd,
i have applied for junior engineer 2 c&w for Guwahati RRB please send me last five year question paper
In India why is the supply frequency 50hz? I need a particular answer for it..
If the characteristic Impedance is equal to load Impedance then…… a) voltage will be increased b) power transmission is zero c) …… d) max. power is transmission to load
What is a differential amplifier? Also, explain cmrr.
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero