Answer Posted / aziz rehman
power factor is tghe ratio between Active power and apearant power
PF=KW(actvie power)/KVA(appearant power)
| Is This Answer Correct ? | 27 Yes | 0 No |
Post New Answer View All Answers
What is lifting power for 1 wb/m2 and 1 A magnet?
hello if any one have papers vof hpcl or sail, plz send me
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
What is the difference between a 3 winding and 2 winding Potential Transformer
What is the formula to calculate the rating of power cable for three phase current.
How to measure the earth resistance value in a concrete pavement(flood light area)?
Dear all: Recently we got a question about Interface between PMS and SAP-PM.once we got a update message from PMS.we should set the deletional flag for functional location in SAP system.Is there any FM or BAPI to use?There are only functional location create and change provided by SAP. Best regards!
What is the difference between UPS & inverter ? which UPS is better and whos got the edge ? what is the difference between & inverter ? which UPS is better and whos got the edge 12 V , 24 V , 36 V etc what are the advantages of 12 V, 24 V , 36 V etc and what are the disadvantages of 12 V, 24 V, 36 V etc thanks
How can we calculate the efficiency of a Running (On-Load) Motor ? What parameters are required and what is the method ?
How does PLC work for sychronising of Two or more DG sets?
how many synchronous motor are there in any power plant
Explain and give examples about VCB?
How to Make relay co ordination chart for a Electrical power distribution of a plant
percetans
Meter p.t. ratio= 3×230/400 , c.t.ratio = 3×1 (2) A what is m.f.
