Answer / chandra mohan

Capacitor is not a constant source of voltage and current as
well.It shows transient behavior of current and voltage when
applied to a some resistance or load and it discharges
almost instantaneously that does not serve the purpose thus
batteries are used.

Answer / karthikeyan

THE MAIN FUNCTION OF THE CAPACITOR IS TO CHARGE AND
DISCHARGE ...IT BASICALLY MADE OF DIELECTRIC
ELEMENT ...BATTERIES ALSO HAVING SAME FUNCTION BUT IT
CONTAINS SOME CHEMICAL METALS ..LIKE LED ACID,NI ,,ETC...

Answer / viswanath

all capacitors hav equal
charge on both plates so
same potential .but bot
electrodes of battery in
most of the cases r not
of same potential.a
curent flows inside a
batery too.but actualy
conduction taks place in
cptor thru electrostatic
induction.and some btry
once discharge cant b
rechargd

units of pressure,flow, level,temperature? principle of pressure gauge? calibration of pressure tx., level tx., temperature tx.flow tx.? description of two wire ,three wire and four wire R.T.D.? WHAT IS INPUT AND OUTPUT OF TX.? WHAT IS INPUT AND OUTPUT OF R.T.D. AND THERMOCOUPLE? WHAT IS HOT LOOP AND COLD LOOP? WHAT IS INPUT AND OUT PUT AND OUTPUT OF D.C.S. AND P.L.C.? PRINCIPLE AND WORKING OF HART? WHAT IS PNP AND NPN PROXY? CALIBRATION OF PRESSURE ,LEVEL ,FLOW SWITCH? DESCRIPTION OF FIELDBUS FOUNDATION? WORKING OF SOV.?

2 Answers  

---

In bimetallic temp. Gauges why does metal strip bend? Why do we use low expansion factor metal and high expansion factor metal in bimetaliv strip?

1 Answers   Process Control Technologies,

---

what is ILD

1 Answers  

---

State four different types of flow measurement.

4 Answers   ADMA OPCO,

---

What is procedure on mmwc in to tph

2 Answers  

---

OBJECTIVE TYPE QUESTIONS OF ANALYTICAL INSTRUMENTATION

0 Answers   Fauji Fertilizer, GSECL, NFL, Power Plant,

---

what sud u do if u dont get feedback from control valve?

1 Answers   Siemens,

---

what is three element loop

7 Answers  

---

Distributed control system

1 Answers   CCIE,

---

In split range control, we will control 2 outputs with time interval. Eg :(with 4-20 ma signal, for 4-12 ma we are operating one control instrument like valve & for 12-20ma we are operating other control instrumet (other valve). If we get a signal of 15ma to first instrument (Valve 1), what will happened to the first valve, and if we get signal above 20 ma to 2 valve what will happened ?

3 Answers  

---

there is one orifice plate already installed on 3" line, but my previous engineer(who is not working here) removed that tx, but now i want to take it in to the process, so now what i have to do now? flow fluid is hytherm oil of temp. 260deg & pressure is 3bar.

2 Answers  

---

whats the diff b/w zero pressure and obsolute pressure

4 Answers  

---