Answer / vinoth kannaa

capacitor banks are highly used in substations for
increasing the power factor. depends upon the load type
highly used by the consumer its value is to be selected.But
most of the loads are inductive in nature.So the power
factor will be lagging in nature.In order to increase the
power factor upto unity level the capacitor banks are
used.But during midnight time the power consumed by the
consumer are very low.At the time we require low capacitor
bank values.It can be explained by the following
equations.we know that
C=Q/V and P=(3)1/2 VIcosO
As phase angle between the voltage and current increases in
the leading side means the power factor will be increased.

Answer / pardeep singh

capaster bank is used in substation for example 132kv to
improve the power factor the capester bank rating is depend
upon the consumer because tn our country mostly enductive
load is used so at the day the sub station mens used
capester bank mostly but at night the consumer consumption
is less so the power factor improve ment is less at night
p=q/v
p=vicosphy

WHY SPEAKER OUTPUT IN WATTS??

2 Answers  

---

low voltage means how much voltage? extra low voltage means how much voltage? medium voltage means hos much voltage? high voltage means how much voltage? Ex: low voltage - 1volt to 240volt like this

3 Answers  

---

Why the core in the distribution transformer is in even number

1 Answers  

---

an off load but energized 11/0.4 KV, 1250 KVA T/F has a power factor of 0.65(capacitive)..!! why is it so, though T/F being an inductive device ??

4 Answers  

---

Sir,In our company there are 3 caterpillar make(capacity:(1) 3.3KV,2.5MW(2)3.3KV,2.5MW & (3)3.3KV,1.9MW) & 1 deutz make (capacity:11KV,3.8MW)gas engines utilised,all are running in paralell. There are three transformer utilised,(1) 6.25MVA,3.3KV/22KV,Impedence voltage:6.7% used for two generator,both are 2.5MW(2)5.5MVA,3.3KV/22KV,Impedence voltage:7.2% used for one generator of 2.5MW & (3) 5.5MVA,11KV/22KV,Impedence voltage:7.8% used for one generator of 2.5MW.all generator breakers capacity of 1250Amps. Sir,I want the details of fault level calculation of generator,transformer individually & for whole system. If you require any information from me.feel free for contact me sir.pl.send the answer of my question as the earliest as possible.

0 Answers   Piramal Healthcare,

---

What is sunrise meeting ?

1 Answers   KSEB,

---

compressor compresses air means exactly what happens?

2 Answers  

---

Why the power factor improvement is so important in industrial loads

0 Answers  

---

what is the full form of XLPE adn there use.

4 Answers   Voltas,

---

What is the difference between surge and impulse?

4 Answers  

---

How we detect the leakage current of 11 KV H.T. motors and waht is the maximim limit?

3 Answers   Ambuja, Pristine,

---

to calculate voltage drop of cable which current we consider that means full load current or panel size?

2 Answers  

---