why low pressure side of the turbine is connected to the
alternator and not the high pressure side??
Answer / vamshikrishna
to counteract the large axial thrust developed on the
tg(turbine generator) shaft, because of the impingement of
the high pressure, high temp steam on the turbine inlet
side( at high pressure side), we place the alternator on low
pressure side.
| Is This Answer Correct ? | 4 Yes | 0 No |
what are the factors to be considered while design the breaker either HT or LT??
How to control speed of DC motor with AC power?
What is the working principle of ceiling fan?
can we synchronize star system generators with delta system generators?
Why CT secondary should not left open??????????
IF 3 NOS.OF HEATERS,3KW CAPACITY EACH,1 NO.HEATER CONNECTED IN R PHASE,1 IN Y PHASE AND 1 IN B PHASE.THEIR END POINTS CONNECTED IN STAR.IF I CONNECT THIS STAR POINT TO NEUTRAL OR DO NOT CONNECT TO NEUTRAL.WHAT WILL THE DIFFERENCE.
what is difference between armoured cable and un armoured cable
To avoid arcing what we connect in earthing.
why does voltage generation at 11 kv?
1 hp single phase motor is more likely to get hot thsn inone hp 3 phase motor its true or false? If true why?
3 Answers Focus, Focus Energy,
What is the out put of a CT? How the ratio is decided ?
What would be the ratio of a Delta-Wye tranformer having 48000 volts phase to phase on the primary and 4160 volts phase to phase on the secondary?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)