Answer / k.prakashchandra

Current high but low consumption

Answer / raghavendra

power factor is the angle between currnt and volatge. power
factor is unity maintained cost is less per unit because
capacitor banks depends on load conditions rating of
capacitor is placed where the less than unity. utility of
power is less .reactive currents is more pf is less

Answer / divesh devadas

This Question have a simple answer that is EFFICIENCY...

Master trip relay code no

2 Answers   TR,

---

what is automatic voltage regulator?we can control the vlotage by using fuzzy controller in matlab?why we go for fuzzy?

0 Answers   DEWA,

---

What will happened if the neutral of secondary of Xformer ( Star point) Note it's above KVA rated Xformer

0 Answers   Equate,

---

in single phase converter, the no.of scr's conducting during overlap a)1 b)2 c)3 d)4

0 Answers   Engineers India,

---

what happens when current(ac or dc)flowing through a boucket of water?please describe it.

3 Answers  

---

why servomotor motor? where i apply for best output?

0 Answers  

---

why are you interested in joining in core company instead of joing in software company

11 Answers  

---

what will happen at secondary side of transformer if i increase voltage at primary side?while V1*I1=V2*I2 will secondary voltage or current increase?

2 Answers  

---

why we are using large cross section cable at load side and small at other (11kv to trsfr)side of transformer? when the load increses current at both side increases,right?

2 Answers  

---

Ferranti Effect says that voltage at the receiving end is higher than that at the sending end. How is it possible?

4 Answers  

---

Can any answer me ,What will be the range of C.T coil for L&T energy meter EM301 used for 180 kva DG set

0 Answers  

---

Give the expression for the frequency of oscillations in an op-amp sine wave oscillator?

0 Answers  

---