Interested to Buy Any Domain ? << Click Here >> for more details...
what is power factor when in view of a lineman
- 3 Answers
- 7108 Views
- KSEB, I also Faced
- E-Mail Answers
Answer Posted / raghavendra
power factor is the angle between currnt and volatge. power
factor is unity maintained cost is less per unit because
capacitor banks depends on load conditions rating of
capacitor is placed where the less than unity. utility of
power is less .reactive currents is more pf is less
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what is high and low cut off voltage of BB and DG at SPS????????
WHAT IS MEANT BY INSULATION CLEARANCE IN VACCUM?
Dear Respected sir how to test ABB REX521 protection relay by relay tester.
Is it possible to make a 5P10/ CT Ratio 50/1A Burden 5VA
What is the maximum percentage voltage drop (vd%)for a motor control center
What happen to the transformer if the OLTC frequently used for lower and raise occured 50times daily?
If symmetrical fault occurs at the terminal of a synchronous motor then how the motor will act...explain it..
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
what are the condition that makes hooter blow?
Suppose a 3 phase, 2 pole, 440V induction motor is driving a flywheel of 600mm diameter, 150kg mass. By using v-belt and pulley, the speed is increased to 4500 RPM. What will be the effect on motor current?
What is Auto Mains Failure Panel & Auto Synchronizing Panel
what is inverter and converter
how to changeover ups in this power failur time?
What is T’Q and X’Q and X’D ? and what is saturated as well as unsaturated ?
When can we take Neutral as common neutral link?
