Answer / mohammed amjath

As a cable jointer he should follow the safety first.A
jointer should use the measurement drawings in the
jointingkit.if he is not using it may cause shortage of
cable.Improper crimping will cause failure of cable
joints.Then the goverment authority will cancel the licence
of the jointer.A good jointer will first do meggering of
cable,Proper mesurement,And good crimpping.

any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?

0 Answers  

---

If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?

0 Answers  

---

Initially motor starts with star connection ,after few timing changes to delta connection, why the motor should run continously in star connection,it gives high torque & low current?

3 Answers  

---

give information about REM5453 & SPAJ Relays

1 Answers  

---

When neutral is grounded in electrical circuit?

9 Answers   Balco,

---

During Millivolt drop test current leads are applied in the extreme ends and voltage leads are given just before the current leads.. what will be the difference if voltage leads are given in the extreme ends? and why?

1 Answers  

---

please send me previous year questions of jspl through which i could prepare myself for the test.

0 Answers  

---

What is Bolted fault?

0 Answers  

---

what is mean by transition resistance of transformer?

0 Answers  

---

What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?

0 Answers  

---

What is Automatic Voltage regulator(AVR)?

6 Answers   Cummins,

---

How many types of AC current?

8 Answers  

---