Answer / vermas

No.  No.  No. Its a thermal current and it is, 1.5 times greater than normal rated current

Answer / ramesh kumar k

Ith is called Thermal Current It is also called Schort
Circuit Current Isc.

It is nothing but the current which flows in the line if
there is any fault in that line...

it is generally 100 times to the normal rated current.

Answer / barkha jha

Ith is thermal overload current
Ith = .90Iflc

Answer / genious007

ITH is nothing but current third harmonics
---------------GOD is solutions of all problems.

How to calculate the phase to phase clearness of HT /// LT bus bar?????

0 Answers  

---

What is the role and reponsibilities of Electrical Engineers in construction field?

12 Answers   ETA, Garg Electronics, L&T,

---

what type of motor is used in fan

6 Answers  

---

why do we use 3 single phase instead of one 3 phase?? though vee connection is its advantage but what is the hidden reason behind it??

2 Answers  

---

What are the protections for safe running of electric generator?

0 Answers   Hetero,

---

How much ampere rating on LT side of distribution transformer and also on HT side of 200KVA transformer

2 Answers   ABB,

---

How do you reverse the direction of rotation of a FAN?

13 Answers   CPCL, IOCL,

---

Hydro P.P. run @ 600 rpm,8pole, Nucler P.P @ 1500rpm 4 pole , ThermlP.P @ 3000 rpm 2 pole.Why this diffrence??? when we can generate electricity @ 600 rpm then Why we had incresed speed in NPP & TPP???

3 Answers  

---

1. alternator has full load regulation of 4% when pf of the load is 0.8 lag, 1500 rpm. full load regulation of 1400 rpm for 0.8lag will be ________ ?? 2. torque angle of a sync m/c operating from a constt voltage bus is usually defined as space angle between _______ . 3. method most effective in finding out no load losses in large DC shunt motoris ______ . 4. current carrying capacity of fuse material depends on ______ . 5. coil has res. 10 ohm, inductance 1H. what wil be current after 0.1sec after switching on to a 500V DC SUPPL ? ? 6. effect of phase lag compensation on servo systems ___________ . 7. rotor of a dc machine is usually supported upon ______ . 8. DC motor is preferred to AC motor in which application ?? 9. 3 nos of 10:1 Xmer are connected in Star-Delta to supply a load at 230V.the supply voltage must be ______ . 10. voltage source produces max current in which circuit. 11. cal. power, if current and voltage are out of phase by 90 degree. 12. suitable length of Xmission line of power at 66 KV. 13. Which of the theorm helps in simple computation when the load across a ckt is varying ?? 14. what is the adopted line length for power Xmission of power by cables ??

5 Answers   TATA,

---

wat is the first thing dat is needed, 2 lay a cable in some area??

0 Answers  

---

what is wave traps and why it is been used in switchyards?

1 Answers   NHPC,

---

Why CTs are connected in star on T/F delta connected winding side & in delta on T/F star connected winding side for T/F differential protection?

2 Answers  

---