why HT motors are earthed only at equipment side & for it's single co

why HT motors are earthed only at equipment side & for it's
single core cable with aluminium wire armoure using?

Question Posted / nishad

1 Answers
4193 Views
Legrand, NLC Neyveli Lignite Corporation Limited, I also Faced
E-Mail Answers

why HT motors are earthed only at equipment side & for it's single core cable with alumin..

Answer / arun 7389944985

if any phase shorted to earth that time current flow div
into 2 way , CBCT senes half current only, but u earth at
only cbct end full current flow throw cbct ,then get
protection trip

Is This Answer Correct ?

1 Yes

1 No

Post New Answer

More Electrical Engineering Interview Questions

how to reduce the magnetizing current in distribution transformers

1 Answers

Why we use shunt coil in breaker??????????

7 Answers

Which types of following motors are most efficient?

0 Answers

How to conduct a Hipot test on a 11KV cable?

2 Answers

what is inverter and converter

7 Answers Shrishti Power Technologies,

Why we oil in tranformer/

5 Answers

Let me know that how i calculate the alternator sub tranciant reactance and tranciant reactance.

0 Answers

What is the difference between "Earthing" and "Neutral"?

10 Answers Power Grid,

Hot Water System (HWS). Will a 30ma elcb have more nuisance tripping than 100ma elcb

1 Answers CIMC,

ALL HT /LT PANEL TEST? DISCRIPTION.

0 Answers Essar,

what is diffrances between fuse and breaker protection? which one is best?

2 Answers Essar,

My ups output shows 230 v between phase and neutral,but show zero between phase and earth.Is the system/installation is correct.If not what will be the possible reasons

4 Answers

For more Electrical Engineering Interview Questions Click Here