Interested to Buy Any Domain ? << Click Here >> for more details...
why HT motors are earthed only at equipment side & for it's
single core cable with aluminium wire armoure using?
- 1 Answers
- 4307 Views
- Legrand, NLC Neyveli Lignite Corporation Limited, I also Faced
- E-Mail Answers
Answer Posted / arun 7389944985
if any phase shorted to earth that time current flow div
into 2 way , CBCT senes half current only, but u earth at
only cbct end full current flow throw cbct ,then get
protection trip
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
why induction motors are rated at 0.8 power factor.
sir i completed apprentice in TNEB.apprentice is eligible for 'c' licence
How equivalent impedance is calculated in thevenin theorem?
why the NGR (neutral grounding resistor) always OFF during DG off?
WHY THE DIMENSION OF TWO SAME RATED MACHINE IS DIFFERENT ?
How to control motor gearbox speed and friquency? If length of cable and dia given, how to measure the voltage drop?
If a transformer primary winding operates at 240v, the secondary at 120v and the load is 1500w & the transformer is rated at 92% efficient, what's the current flowing through the primary winding of the transformer? What is the formula for finding this?
How colour picturetube works & how many year it will works.
State how to produce a constant rotating field by application of alternating currents to stator armature of a three-phase squirrel-cage induction motor
in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?
How to design a Unit auxiliary transformer for a power house having a unit of 65 MW and Generating voltage of 11 KV and Secondary voltage of 433V
What is the function of the circuit breaker failure relay?
how to get electrical supervisor competency certificate in gujarat. i did 3 year diploma in electrical
A generating system will have a total capacity of 300 MW. Find the probable forced outage when the capacity is supplied by two 150 MW units. The operating probability of all units is P=0.98 and forced outage probability rate Q =0.02 .
how to set the time in digital timer ?
