iii) A shunt motor runs at 70 rad/sec from a 460V supply and takes in an arma

iii) A shunt motor runs at 70 rad/sec from a 460V
supply and takes in an armature current of 100A. Resistors
of 2.52 ohms and 1.64 ohms are connected in series with the
armature and in parallel with the armature respectively.
The field excitation remains direct from the 460V supply
but the generated torque is halved. Determine the new
running speed. Neglect brush voltage drop. The armature
resistance is 0.4 ohms.
[15]

Question Posted / 209503454

1 Answers
2610 Views
I also Faced
E-Mail Answers

iii) A shunt motor runs at 70 rad/sec from a 460V supply and takes in an armature current of 100A..

Answer / ajay kumar

44rad/sec

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

If the load of transformer is getting more than its rating,,,than how to overcome this problem? Suppose thee rating of transformer is 315kva and the load is going beyond than the rating say around load: 352kva... Than how can we solve this problem without deducting the load.

14 Answers Hyundai,

what is the difference between diode and zener diode?

4 Answers

wht is this amps in power consuption and how can we convert that into consuption hours ? i am a sales executive of a energy saving lamps .

5 Answers KSEB,

How to decide the input and output circuit breaker for a 1600kva transformer.Is there any calculation is involved.

5 Answers

In a star-star connected h.t transformer why we use NGR on the secondary (l.t)side.

3 Answers Star, TATA,

How can I communicate with an Areva MiCOM P121 relay by RS485 port? In other word, which command can I send and what information can I have recieved? please send some refrences, please. thanks

3 Answers

how to calculate the size of the HT cable

0 Answers

What will be the sampling frequency that reveals the same sampled signal?

1 Answers CCP,

What is required of exietation to the alternater.

4 Answers

what is the maximum demand how it is defined

1 Answers

what is the difference withbeen lighting capacitor and motor capacitor?

2 Answers

after parallaing two generators current is shooting up in both the generators.for ex: load is 400 kw..after paralling and load sharing current in running gen is approx 900 amps and incoming is 750 amps which is too high when trying toshift the load current in incoming gen is coming more than 1300 amps and both getting tripped and making blackout..

3 Answers

For more Electrical Engineering Interview Questions Click Here