I have 11KV/415V power distribution transformer. I have found unbalance current in LT (415V) side. Also observed that unbalance voltage (3V) at LV side due to HV side unbalance voltage. What should I check for this? Also, the same LV side load can run in balance on captive power.
1 5258What is the basic principal, by which DC voltage level is increased more than the supplied AC voltage during conversion. As upto AC level it is contorrled by firing anlge but after maximum level how is it possible.Please clear picture. OR we have to supply the higher level AC?
1967Why is starter necessary for a three-phase induction motor?
BMM, Essar, Hero MotoCorp, ITI, Maruti Suzuki, Supertech, Watt,
37 179325What are the advantages of star-delta starter with induction motor?
Merchant Navy, Naval Academy, Samundra Institute of Maritime Studies, YMCA,
7 46916How will you determine the rating of a motor for continuous duty variable load motor applications?
1 4591Post New Electrical Engineering Questions
what are the different methods for the starting of a synchronous motor.
What kinds of decision are made about CT from it's Knee point(voltage & current)?
what is draiv work
Difference between earthing & grounding.?
Please explain the following and how these are working with PLC unit 1.I/O Module 2.I/O Device 3.Adaptor Card 4.Ribbon Adaptor 5.RS 485-FC
What are the advantages of stationary armature and rotating field system?
How the annunciator works ? How to do its wiring
Mr. mohh sahid m not satisfied for ur answer to the que weather the size of transformer increases or decreases withchange in fr for more detail go to the answer given by me
what is meant by 3rd hormonics ?
1.What is the range of stator resistance of 3-phase induction motor? 2.Two electrically operated vibro motors are foxed in parallel direction in vibrating feeders. what is the direction of both vibro motors?
Dear All, I am new in construction company , my boss ask a question at time of interview , If we have 60MW generation and Single Power Transformer step-up we have. if CMR 50/60MVA , ONAN, ONAF respectively , is it sufficient or not ? for that much power to transfer,
how dose servo motor works
how to calculate insulation level of transformer?
How to design harmonic filter at the project stage without nowing the harmonics levels
Dear all, I want to use Induction motor to open and close a 1 ton door. How much power do I need. Thanks