Golgappa.net | Golgappa.org | BagIndia.net | BodyIndia.Com | CabIndia.net | CarsBikes.net | CarsBikes.org | CashIndia.net | ConsumerIndia.net | CookingIndia.net | DataIndia.net | DealIndia.net | EmailIndia.net | FirstTablet.com | FirstTourist.com | ForsaleIndia.net | IndiaBody.Com | IndiaCab.net | IndiaCash.net | IndiaModel.net | KidForum.net | OfficeIndia.net | PaysIndia.com | RestaurantIndia.net | RestaurantsIndia.net | SaleForum.net | SellForum.net | SoldIndia.com | StarIndia.net | TomatoCab.com | TomatoCabs.com | TownIndia.com
Interested to Buy Any Domain ? << Click Here >> for more details...


I have 11KV/415V power distribution transformer. I have
found unbalance current in LT (415V) side. Also observed
that unbalance voltage (3V) at LV side due to HV side
unbalance voltage. What should I check for this? Also, the
same LV side load can run in balance on captive power.



I have 11KV/415V power distribution transformer. I have found unbalance current in LT (415V) side...

Answer / k.prakashchandra

Inter -turn short on the HT side is suspected

Is This Answer Correct ?    0 Yes 0 No

Post New Answer

More Electrical Engineering Interview Questions

what is the Maximum voltage range for single phase

4 Answers  


The ohm is the unit of:(a) Charge(b) Resistance(c) Power(d) Current

2 Answers  


How to calculate pitch, gauge of winding wire, and No. of turns for 30HP, 3 phase, 4 poles 50Hz, 380V induction motors

0 Answers  


What is the function of a turbo charger in a 1000kva DG set

6 Answers  


What is the diffrence between PL Lamps and CFL Lamps

5 Answers  


can we make a loop between neutral and body for grounding?

2 Answers  


what happen if turbine trip ,g.c.b not open and excitation on condition?

1 Answers  


Dyn1 transformer vector group testing how to do

0 Answers  


How can calculate ups battery back up time?

25 Answers   Cisco, Cooper, Pronet, Wipro,


can you give main difference between ELCB And RCCB?

38 Answers   MCB Bank, Reliance, Wipro,


coil is consist of

1 Answers   Enercon,


why we are using the 2 slope in differential relay?but in busbar differential we are using only one slope. what is the reason.

1 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5086)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4456)
  • Electrical Engineering Interview Questions Electrical Engineering (16639)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)