hi frnds...pls send me aptransco previous papers .....pls..pls,,,(madhar.rocking@gmail.com)and suggest me some websites
1 2192What is the correct procedure to shutdown VCB in 11kv substation.safety and work procedure
EGA,
3 19025I want to know what is the short circuit level when 8 NOS 2000 kVA, 415v, 50hZ generator connected in paraller
1 4503What will happen to the speed of synchronous machine subjected beyond the pull out torque? Are the behavior shown by rotor remains same for both the alternator and motor?
1 4377I find that underground strip-armoiured,4core,LT PVC cables in an earthed power distribution sytem are occasionly found in charred condition-with no trace of it except ash. Is this because of no proper earth connection/continuity (giving rising to high armour resistance)in the joint enroute or because of insufficient capability (again due to high armour resistance)of cable-armour to carry fault current or due to neglected /unprotected overloading of the cable or due to high armour currents caused by power thefts where only phase(s) are unauthorisely tapped & at the point of poer consumption earth terminal is established by burring underground a not so good earthing rod (or using an underground water pipe for the purpose)
1 4182Post New Electrical Engineering Questions
Enlist four components of electrive drives.
Dear all i want to know SEWA Electrical Supervisor Licence test Previous Year Questions ? If any body know please send to me zohairaukllah@yahoo.com
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH
Draw the vector diagram and condition for the following: 1) Dyn1 2) Ynd0 3) YnYn0
Hi friends, i m electrical engineer i want a cdr for migration purpose so anybody have information about this then send me on jayesh_ee88@yahoo.com.please try to me
hi friend i am going too attend for hpcl in this month please help me by sending written test question papers i am in the stream of E.E.E
What the main causes of transient interruptions on Over-Head Distribution Lines?
pls someone send me sample question papers along with the key.thanks in advance
if any body have question paper of railway (section engineering),then plz send me .i will thank of him/her.
hi frds, i m electrical engineer.can i get cdr for electrical engineer if u have then send me on my mail id its jayesh_ee88@yahoo.com.please help me frds
please give some hindalco placement papers for written exam
What types of CMOS memories have you designed? What were their size? Speed? Configuration Process technology?
hi frenz,its aswathy.i hve aplied for the hpcl test on feb,pls send the test patern & the placement papers as soon as possible. mail-id :kjaswathy@gmail.com
Is there a standard depth of gravel fill in Substation Switchyard? Please give a design/drawing. Thank you.
Circuit diagram of tube light without starter using electrical choke