when we conduct high voltage testing why milli amp. is
required?
Answers were Sorted based on User's Feedback
Answer / iamdon
Generally at high volatges we test the insulation level.
The insulation resistance is very high(order of Mohm).So
leakage current flowing is very small(order of milliampere).
Author:arbelectbit@yahoo.com
Is This Answer Correct ? | 4 Yes | 0 No |
Answer / brijesh
you can allsosaid like this as ohm's low current is
inversli proposnal to the voltage
Is This Answer Correct ? | 0 Yes | 0 No |
what is specific gravity of a battery if specific gravity increase/decrease,what will happen to the voltage/current of the battery
what is inrush curent.
what are the basic concept to design a out door Substation?
what is load cell? whrere its used ? how to measured?
state the functions of different parts of star delta starter.
effect of single phase transformer on full load current?
Anybody tell me about modbus hex address of l&t trivector meter er300p??I want to read voltage,current,kwh etc via rs485...If anybody have a manual then send on my mail..Brijeshmodi18@gmail.Com
when voltage increases current decreases & vice versa why it is so?
29 Which of the following breaking method save energy? A regenerative breaking B plugging C dynamic breaking D none of above
why a tester wont shock while testing the power in house
why the efficiency of generator is more than the motor in case of swinburne's test????
We are installing a 1.6 MVA transformer at our crusher plant and the feeder of HPSEBL is 2 km away at substaion . and a VCB is installed in the substaion which is 2 km away from transformer so we need another VCB near the transformer.