Interested to Buy Any Domain ? << Click Here >> for more details...
How to replace dia of bar in beam like 25mm 3no.S at bottom But due to some reason on site 25mm bar is not available Then is it ok to provide 20mm 4no.S? Give description or Formula to calculate area of steel and replacement?
3 23506what are the tests conducted on cement,aggregate and concrete?briefly explain that tests procedure and limits adopted for safety side.
1 10039how to frame the sentence in voucher pad ? Description : 1.Food Expenses during site visit 2.Stamp Paper approval expenses 3.Travelling expenses 4. sweet distribution
2169How we can calaculate materials required for block work(1m3) block size 33cm x 20 cm x 17 cm, mortar 1:6
3 8705how we can calaculate cutting lengh for stiruups 6mm dia . column size 20 cm x 30 cm, cover 20mm
8 13117(Project Management Topic) What are the important criteria in the successful realization of the project?
2174Post New Civil Engineering Questions
what is the procedure involved in preparing mix design of m15 grade as per IS-10262-1982
may i know the detailed description of cutting length
what is box type waterproofing and how it is exsiccated and what is the method of doing box type waterproofing
What is the diff b/w ROAD TUNNEL & RAILWAY TUNNEL ??
A super elevation of 60 cm has been provided on a 8m wide road and a curve of 260m radius .calculate the max.speed in km/hr of the vehicle that can be negotiated safely? Plz answer with full solution.thanx
importance of the soundness test to determine the quality of cement use for any construction
What expenses counted in contingencies and how much it is in related to built-up area of the building.
Why we provide hair pin for shed
sir when can we expect the AEE results and when will be the interviews sheduled please guide us in this regard thanking you
What is the use of water table & Kreb stone for drain
With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr
How to calculate quanty of steel in four leg stirrups?
Design a cantilever type retaining wall to retain sand for 4m above the ground. The sand fall slopes at the rate of 1 vertical to 2 horizontal. The weight of sand is 18000 N/m3, the angle of repose being 30. The safe bearing capacity of the soil is 200 kn/m2 at 1/25m below the ground level. Use m 15 concrete mix.
what is the minimum cement content for M20 & M25 as per is code -456(2000).
Why do we not deduct steel volume to find actual volume of concrete in practical as we have studied that,,, actual volume of concrete = volume of column- volume of steel pls explain with reference of IS code?????
