Answer / akrmsb

It is done by the rebound hammer test.

A cube of size 150mmX150mmX150mm is kept in the machine and a gradual load of 140kn/cm2/minute is applied on it till it fails.

Then the reading on the machine is divided by the area of cube to get the actual compressive strength.

For example area of the cube is 150mm X 150mm = 22500mm2
and the reading from the machine is 751000 n/mm.

Then the compressive strength of the cube will be 751000/22500 = 33.37 N/mm.

Answer / skj

we put the cube in compressive testing machine then apply
load in kn unit then we note downthe reading just srating cracks

Answer / ronak shah

putcube in compressive testing machine, give pressure 140
kg/sqcm/minute.

strength= load/area

if you want to know the solid cube density. take weight of
cube.
forumala;
density=mass/volume=weight of cube/volume of cube
(0.15*0.15*0.15)

ans gives you density of solid concrete.

if you want wet concrete density then take cylinder 10
liter weight of empty cylinder then fill with concrete

weight of concret/volume of cylinder its gives density of
wet concrete.

Answer / md sajid

Qube strength

Answer / gourab

By Rebound hammer test

what is the quantity of cement( in bags),sand and aggregates required for 1 cmt of M 25 concrete

3 Answers  

IS STEEL BARS IS AS PER ISI TRANSVERSE RIBS SHOULD BE UNIFORM IN DISTANCE, PLEASE EXPLAIN WHY,

0 Answers   NCC,

What is rate of concrete surface rendering work per sqm

0 Answers  

what is Tsunami. explain it's formation.

7 Answers   NHPC,

what is mixing ratio of M25?

14 Answers  

What are the specification of good quality sand for plaster and brickwork?

2 Answers  

if dia of inner circle is 42 m and depth is 1.5 m and width is 1 m ,then whait is the quantity of steel?

0 Answers   AZT Techno,

how to cal 1:4 in brick masonary work cement and sand?

1 Answers  

what is SDLC ?and write a 'c'program for to swapping the three numbers?

0 Answers  

In Rcc work what ratio we need?

2 Answers  

in levelling operation the first site on any change point is back site the second site on any change point is fore site the line commenses with fore sight & closes with backsight the line comensses with back sight & closes with fore sigh

0 Answers  

why construction joint in the slab should be l/3 of span? what's the technical reason for that?

1 Answers