Interested to Buy Any Domain ? << Click Here >> for more details...
-
Civil Engineering (5086) - Mechanical Engineering (4456)
- Electrical Engineering (16639)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
When i went to a interview the interviewer ask me a question for that i cant able to answer him if anyone knows answer me How will you design a capacitor bank for a plant? if my p.f is 0.6 i have to improve it to 0.9 or 1 what kind of steps i have to do? and is there any formula for calculating this?
2 5182When i went to a interview the interviewer ask me a question for that i cant able to answer him if anyone knows answer me How will you design a capacitor bank for a plant? if my p.f is 0.6 i have to improve it to 0.9 or 1 what kind of steps i have to do? and is there any formula for calculating this?
6 8659What are the solutions for avioding sulfide formation at bimetalic (Copper &Aluminium)overhead joints?
HAL,
2 5174In three pin socket normally three pin in between three pins earthing point is more thickness why?
6 13829the distance from my office to d.g is aprox 400mtrs and voltage drops ibn my office near about 40 volt what should i do p[ls suggest.
4 5658
what is arc flash and what are the hazards involved
What is modbus?
WHAT IS VCB SAFETY
What is DTR erection?
Explain at what voltage does land line telephone operate?
Why head of a centrifugal pump is independent of density of fluid?.
have a clutchless car or bike clutch for power transmission???
Who built the trans alaska pipelene?
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
why do we measure VIBRATION in -24vdc and why we adjust gap voltage -9vdc to 10-vdc? i am trying to get this information since 5 years, yet i haven't get reliable answer, i hope i can get from you.
State the points to be considered for selecting a particular type wiring.
interviw tips for bhel supervisor trainee
Is there any relevant technique to produce power from light and heat energy of the sun simultaneosly from same rays of light?
pls any one send me the last 5 years rrb QP - hari.devarajan@gmail.com
How can you prevent bridging in a dilute phase pneumatic conveying system?
