Answer / carl_ellis

A 'vent' or 'fill port' is installed at the top of a
condensate pot, facing upwards, so the water can be poured
through the vent's opening to fill the impulse tubing/piping
and the condensate pot.

Carl Ellis
Measure First

what do you mean by smart instruments?explain with example

4 Answers  

---

If you calibrate a pneumatic pressure transmitter, how many adjustments are normally necessary or mandatory?

1 Answers  

---

I have a steam flow DP transmitter that has output swinging. Steam valve is in manual.I have good steam pressure. The impulse lines have steam tracing on them. The steam tracing has a hole in it that is blowing raw steam on the high side impulse line only. Could this be causing the swinging?

1 Answers   Honeywell,

---

What is the difference between working pressure and calibration pressure of a control valve

0 Answers  

---

what is Automation?

3 Answers  

---

how can we caliberate interface level troll

2 Answers   Grasim, IOCL, KOC, Sankyu,

---

what is the meaning if the control valve CV is 27,in terms of selecting procedure?

2 Answers  

---

Can anyone help me with the Question bank(objective type) for complete Instrumentation engineering,either a soft copy or a Hard copy(Book),or the name of the author ,or publisher.

1 Answers   Reliance,

---

What are advantages and disadvantage of the ac supply load cell?

0 Answers  

---

Working principle of magnetic flow meter ......and calibration procedure of e+h magnetic flowmeter...

0 Answers  

---

in the flow caluclation k value how to caluclate.mass flow & volum flow.

1 Answers  

---

I have a MRE200 amplifier for controlling a mitsubishi servo motor, I would like to know how many pulses are required to rotate the servo motor by 1 degree and what must be the pulse width

1 Answers   Essar,

---