Engineering Interview Questions, Answers for Freshers and Experienced asked in various Company Job Interviews

Satellite Systems Engineering (106)
Engineering AllOther (1379)

Engineering Interview Questions

Questions Answers Views Company eMail

how much lap we should provide in columns for Fe-500?

8 13622

What is the difference between Over Molding and insert molding ?

5322

is it possible to export & import power in a same transformer.how

2 6251

What is the difference between diode and a transistor in terms of the direction of current flow?

2215

please send the IS strandard for electrical to sakthi_murugan86@yahoo.co.in

2258

How to produce vapour on steam turbine main oil tank? it is a closed vassel little amount of water is present in purification how?

1 4264

What is the parameter of water tube, boiler water, feed water and condensate water?

ABC,

2 7769

If I have a motor of 1MW with 6.6kv, running at 35% load, how can i save energy without reducing the load ?

Reddy Labs,

2 5189

What is the advantage and disadvantage of dry type transformer?

Bhel,

5 20116

is there any difference in reading or error in value, if we connect the R phase in Y terminal and Y phase in R terminal of electronic energy meter of 11 kv feerders???

KSEB,

1 4617

How to connect field devices to PLC and DCS using a FIELD BUS, DP,MOD BUS(please tell me any extra interfce or adopters need in this case if we use remote i/o s)

3 17685

why inuctive drop is not consider in DC MOTOR

2 4380

what's the difference between abs/inc encoders. apart from the position remembrance what are all the other differences. and what's mean by grey code.

2088

what is reactive and active power?why we need power factor correction?

2 5200

why inductivedrop in dc motor neglected

2 5483

Un-Answered Questions { Engineering }

difference between microcontroller and microprocessor

2049

pls send me rechnical test paper of reliance with answers for last five years??

1966

What are strain gauges?

1088

IN SINGLE PH TRANSFORMER IF LEKAGE IMPEDANCE DROP IS NEGLECTED ,THE FLUX IN THE MAGNETIC CORE and the lekage flux linking a winding are a)proportional to the applied v to the winding i respectively.

2119

1)Why we can use half brick in 4inch wall and 2)why not in 9+inch brick wall

2406

What is the temperature PROFILE OF A FLUID W. R. T. Distance from a sphere to which it is IN CONTACT which is at constant temp.?

2061

dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?

2072

What is industrial engineering? How important are statistics in industrial engineering?

1004

State the factors, for the choice of electrical system for an aero turbine.

1166

What is edge stitching?

how to determine the inrush current of a transformer

2611

Sir 33kva 2 transformer load 900 amp calc 1800 amp mana jayega

1834

what is the criterion for selecting vector group of Transformers ? i mean how to decide vector group of Generator transformer, substation trasformer and transformer at consumer end

2354

when power factor leading above 1 than defect moter and kwh.

1666

How do you prepare Material Recovery Statement for deduction from contractors bills?

1733

For More Un-Answered { Engineering } Questions Click Here