Answer / satish awate

PLC is programmable logic control in this field instrument are connected to input or output of PLC input & output. And PLC are connected to DCS system or SCADA or HMI by a RS232 or RS434 communication cable.

Answer / rajendra singh

first of all I want to tell you connection from field to DCS:

Example: C.V. to Tx. to controller via Ethernet cable to DCS.

Answer / nnnnnnnnnnnnnn

DDDDDDDDDDDDDDDDDDDDDDDDDDDDDDDDDDDDDDDDDDDDDDDDDDDDDDDDDDDD
DDDDDDDDDD

Calibration of controller (pneumatic)

0 Answers   CCIE,

---

when the operation engineer told you that he gives the control valve order to open but there is no response ! what will you do ? and if you found that there is astuck , what will you do ? (note : it is apanumatic valve )

5 Answers  

---

Decibel.

0 Answers   CCIE,

---

A differential pressure transmitter is configured to measure the height of an open tank : height 10m and dia 5m. Suppose this same transmitter is shifted to another open tank : height 10m and dia 4m. What will be the %error in measurement? how?

3 Answers   McCoy Engineering,

---

I am applied 100 % pressure on to the air to open control valve,but the valve is not fully closed..and 10-15% is open the valve. how to calibrate the control valve?

3 Answers   OPaL,

---

how to calibrate 0- 150 psi presure gauge by dead weght tester

0 Answers  

---

Different between control valve and mov

2 Answers  

---

what is the output of conductivity sensor and PH sensor?

3 Answers  

---

What is open loop checking and close loop checking

1 Answers   BARC, NTPC,

---

what is difference between profibus and field bus?

1 Answers  

---

what is skin thermocouple?

3 Answers  

---

need to calculate flow rate with the help of dp range and orifice bore dia and size. range is 0 to 400 inwc and orifice size is 12 inch 150 # rf and bore dia is 7.180 inch. need to calculation for flow rate

0 Answers  

---