Answer / m s kumar

Starting Current is the current taken by an electric
machine at the time of starting. It is typically 5 to 6
times the rated current of the machine. Since torque of an
electric motor is proportional of current (or square of the
current), the starting torque is high or low if the
starting current is high or low respectively.

Answer / pswin

Starting current it the current drawn by the induction motors at the starting period. It is used to choose correct size or ratings of power cable,breaker and starter for that motor.

Answer / kamlesh g patel

starting current of motor is same as inrush current of
transformer.
starting current of motor is about 5-6 times its rated
current & this is due to non availability of back emf
during starting.
motor torque is proportional to the current means high
starting current produces high strting torque which helps
in starting the machine from stndstill condition.

When lag/lead/lag-lead compensation is employed?

0 Answers  

---

Which. Type of motor used in. Fan

10 Answers   Bajaj, HCL,

---

Which rccb 30ma,100ma,300ma sensitivity should be used in domestic line and what is difference, advantage and disadvantage of all three

2 Answers  

---

why r use the wave taper in the substation ?

2 Answers   L&T,

---

what is rated current and operating current?

3 Answers  

---

How can we increase fuel-power ratio of any DG set?

0 Answers  

---

Hello every one I am currently working in IT side but i have an offer to work under 'A' license holder and he says i can get c license what is the use of c license and what shall i do after getting it basically i am an electrical graduate please help me shall i leave this it job and work in electrical maintenance will i have a good future i am confused Thank You in Advance

1 Answers  

---

In Delta connected capcitor bank, One bank failed due to some problem. Can we connect Open delta capacitor bank to 3 phase motor. The motor voltage rating is 6.6KV. IF yes what changes will happen?

1 Answers  

---

Meter p.t. ratio= 3×230/400 , c.t.ratio = 3×1 (2) A what is m.f.

0 Answers  

---

how u select control transformer for a mccb panels or any panels?for expample we hav 440 volts maim supply and control volts is 230v?

0 Answers  

---

what is the formula to calculate voltage drop/loss on 66KV Transmission Line?

0 Answers  

---

hi friends ,iam working as genset AVR service engineer in electrical field from past 2 yrs throughout india . i plan to shift in some other job without travelling in same field because i con't travel,i dont know what i do for that so please guide me what job is suited for me,how i can serch the job please anybody helpme iam totally confused

0 Answers  

---