why power not passes in plastic and rubber material
No Answer is Posted For this Question
Be the First to Post Answer
What is a HRC fuse (Full form)
26 Answers Gammon, HRC, Moser Baer,
Can anyone explain the power flow in flouresent lamps (tube lights) .What are the functions of Starter & choke used there?
what is the saturation point of crgo lamination.
a.)Ammeter and Voltmeter read rms value or avg. value ? b.)What are symmetrical and Unsymmetrical faults?
What are the starting currents of different motors and also what are the running currents, and idle currents?
I have two power supply.a)govt. power b)Captive power.3 phase load connected inside factory.when source change govt. source to captive some motor rotate reverse. Is phase sequence changes when if off & on?If I off generator & on it again is it possible to get changed phase sequence??
why HT motors are earthed only at equipment side & for it's single core cable with aluminium wire armoure using?
1 Answers Legrand, NLC Neyveli Lignite Corporation Limited,
WHAT IS THE WORKING PRINCIPLE OF A GENERATER.how is a GTG (Gas TURBANE Generater) working.plz explane
what is the meaning of improving the power factor (give technical ans not therotical)
why we used stone chips under the transformer area..
Form S and "c" license application both are same? @ tneb portal
how to select rating of HT Panel
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)