Answer / x man

Hi Sis,
There is no need for Addtitional course.
what you had itself is more than enough.
we need to brush up the basics.the core companys are
looking for people who can learn.
also we can learn and handle any job in 6months time.its my
experience

Answer / sathyaram

better u wl do plc,scada,dcs for getting core job placement.
no.of centres available in cities......better u applying
honewell training ceter(hail)..pune....after u finished the
course there,u may got job there itself

Answer / mirza amanulla

FOR INSTRUMENTATION THE BEST COURSES ARE DCS, PLC,
SCADA.APART FROM THIS YOU CAN ALSO LEARN NETWORKING,
UNIX,LINUX,AUTO CADD ADDITIONALLY WHICH WILL HELP YOU A LOT
IF U ARE A DCS ENGINEER

Answer / srikanth

better go to DCS training of ABB,SIEMENS OR honeywell.
in core field and as a girl this will be the best option
for u .

Answer / gowrishankar

nothing u have to do plc & scada then only u get a job easily...if u any doubt ,mail me..good luck

Answer / krishna

In core you can enter as a Design engg for Instrumentation.
So u better go for Detail Engineering course for Instrumentation in chennai.they r theaching instrumentation
Detail Engineering courses in chennai itself.Goog Luck!

what are the standards used for earthing instruments in the field?

1 Answers  

what is orifice plate? Give me best answer?....plz

5 Answers  

what step is taken for ESD ( emergency shut down) in DCS REPLY to hashimka20009@gmail.com

0 Answers   Bosch, Eskom, Sabic,

So I'm a first year apprentice and I'm having a tough time with knowing the difference between AI, AO, DI, DO. I'm having a hard time understanding what devices are which and why. Can someone explain this to me?

2 Answers  

what effects a surging can produce in the compressor

0 Answers   Nemat,

how in the 2 - wire transmitter, 24v supply and the 4ma signal gets in the same path?

1 Answers   Yokogawa,

pls give me presant awerness quistion and answer in my emailid.

0 Answers  

What is instrumentation measurement?

0 Answers  

I work on a electronic positioner transmitter 4211 at the field.I connect my multimeter in series to get the current output then I calibrate it to 4ma in 0% of position of the valve and 20ma in 100% position of the valve.My problem is in the field I get the correct output current based on my multimeter but in the dcs they only receive 40% in a output 20ma of this positioner.Then I try to simulate in this analog card and they receive the equivalent percent on the value that I simulated.Is ther any possibility to reset the zero and span of this positioner 4211 fisher.And what other possibility I can do to fixed this.This is my email add ( landicho_randy@yahoo.com )

4 Answers  

i have 20 kw motor & my vfd drive capcity is 18 kw if possible to use 20kw motor on this vfd?

4 Answers  

why we are using digital signals for I/O & how to measure this signals is getting or not ?

0 Answers  

what is puling in n pulling out in flame scanner system?

1 Answers