Answer / chandra

At least 3 points 3 psi 9 psi and 15 psi

Hi i am aneesh, done btech in applied electronics & instrumentatiin. And then i took mba in finance & marketing.After that i got placement in finance co and worked there for 3.5 yrs.Now i wanted to come back to engineering job.But without engg experience, i may not able to find an opening.i have done a course related to flow meters and ite calibrations. Kindly suggest where should i try to get a job?

0 Answers   Qatar Petroleums,

---

What is feed factor and its Importance in cement industry? How we can solve feed factor?.

0 Answers  

---

what is difference between venturi and orifice

1 Answers  

---

uses of profibus?

1 Answers  

---

To become an Instrument DESIGN engineer, is there any softwares or training to become Instrument Design engineer, plz suggest me, Iam very much interested in designing.

0 Answers  

---

---

capillary type tranmitter using remote seals and capillary tubes filled with liquid of known of known density so if you wanna callibrate it just close block valve just before capilary @ high side & connect druck apply it's calibrated range pressure as normal calibration ensure low side block valve must be closed & if you asking commissioning so this is not a DP type pressure tx so simple if you wanna put in servie this tx just open high side block valve & than low side block same way i do it but still transmitter showing -13 ma.just tell me what i want to do ?

1 Answers   Gasco,

---

What is difference between sensors and transducers?

2 Answers  

---

what is coriolis principle for mass flowmeter?

5 Answers   ABB,

---

what is the difference between AUTOMATION AND INSTRUMENTATION?

7 Answers  

---

What is calibration?

6 Answers   Syscon,

---

Where we cant instal mass flow meter.

1 Answers  

---

transmitter in 3 connection +,-,And test mode so how Use To Test Mode

1 Answers   Essar,

---