Answer / dinesh kumar m

e=eo*E^((-.5*(R/Zs)+(Zs+G))*x)
e=voltage wave after travelling X Km
e0=initial value
Zs=surge impedance
R=resistance/Km
G=leakage/Km
E=Naperian base

what should be correct gas pressures to be a 1.5 ac unite

0 Answers   DDK,

---

if a 3phase 100kva distribution transformer , 400 v,50 hz, 4-wire system is loaded at 160 k.w mostly 1-phase Lighting & Airconditioning split a.c load what will be the net effect on the power system in terms of voltage, powerfactor, current , efficiency of xformer

1 Answers  

---

What are factors to be considered while we selecting the Core Balance Current Transformer for Earth fault protection

0 Answers  

---

what is IP 55 & IP 54 ?

1 Answers  

---

what is the calculation of current when a clampmeter is attached to two phases of any drives.

3 Answers   ABB,

---

how can we test the vector group of transformer

1 Answers  

---

How is operate breaker failure scheme in substation

0 Answers  

---

documented proof that aluminium bus bars are better than aluminium cables

0 Answers  

---

Since phi is the angular displacement between V & I, then why we use phi in power triangle ie. when showing active, reactive & apperent power in triangular manner & if it is ok then where is V & I in the triangle.

1 Answers  

---

Why open circuit test of transformers is conducted at rated voltage??Why not any other voltage??

0 Answers  

---

we convert 66kv to 33 kv to 11kv to 440v. why can't we directly convert 33kv to 440 ?

9 Answers   EMC, Jakson, L&T,

---

STATE WORKING OF SF6 C.B.?

1 Answers  

---