why the crow do not feel the current in overhead line when
it sits on the wire??????
Answers were Sorted based on User's Feedback
Answer / vamsi kaushik
d crow sits on a line with both the legs on the line...
since both the legs will be at d same potential, there will
be no closed loop for d current to flow... hence d crow
doesnot experience any electrical shock
| Is This Answer Correct ? | 24 Yes | 5 No |
It is sitting only one conductor its never touch any other
conductore or ground so it is single pottencial. if you
want any circuit closing thuse want phase neutral or two
phase and three phase
| Is This Answer Correct ? | 4 Yes | 1 No |
Answer / karthik
i have a simple doubt on it. of course we r seeing this s
happening. just i want 2 put up this here.. while we r
approaching 11 kv , 22 kv induction around the conductor or
near d conductor may lead to flash over (at no load @ vge
nly present). why d same wouldnt happen to the crows.....
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / vinod
if you touch the electrical having same potential nothing will happening.
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / santa
the crow is insulating material so it is not feeling the
the current.
| Is This Answer Correct ? | 4 Yes | 26 No |
what are the oils used in transformers cooling? n which type transformer is used in power systems?
how we can calculate power factor in single phase & three phase ?thank u
what is synchronizing panel & its working.
what is the rating of Insulation tester for measure 15 KW, 3 phase 415V 50 HZ induction motor?
why we ground the scondary of current transformer.
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
Earth bits close or open. Which is correct
In 63kva LT Distribution Box Why the outgoing of 63A kit kat is connected to 200 A link disconnector? as the output of kit kat is only 63 A?
explain wiring system
What happens if 25 Hz frequency is applied for 400/200,50 Hz single phase Transformer.Will Voltage increase ?
2 Answers Bhel, Dawlance, IBM,
why we pefer the salient pole for synchronous motor ?
what will be the effect if you were using different brands of outlets?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)