why substation rating interms of 11 multiples???like
11kv/33kv iis there any special reason???
Answers were Sorted based on User's Feedback
Answer / amit goel
due to sine wave form
factor, having 1.11
amitgoelu@gmail.com
Is This Answer Correct ? | 16 Yes | 7 No |
Answer / satyendra bharati
Receiving end voltage is considered 10 percent more than
supply end voltage considering the loss will be 10
percent.so,10kv+10% is 11kv and30kv+10% is33 kv and60
kv+10% is66 kv and400 v+10% is440 volt and so on.
Is This Answer Correct ? | 7 Yes | 3 No |
Answer / ashwin.m.chhadi
i agree wit amit goel due to sine wave form factor, having
1.11 the lines are in multipes of 11.
Is This Answer Correct ? | 6 Yes | 3 No |
Answer / vivek srivastava
As the diversity factor is multiple of 1.1
Is This Answer Correct ? | 2 Yes | 6 No |
i want some interview related questions with their answers which can help for attend the interviews...
A 12.5 hp slip ring motor taking high initial current and its MPCB is getting open.what may be the reason?
what is Fault level? why it is calculated? how will u decide same for our plant?
how to produsing geretor power
What happens when the polarity changes in CT? Explain briefly?
Leading power factor means what? what is the power factor value while in power factor is leading? is power factor greater than one? In some cases i heard pf 0.8 leading then what about 0.8 lagging?
1 Answers Rockfort Engineering,
Can any one help me how to set an overload set the range from 2.8A to 4A , rated motor current 22A, CT 60/5A
Why two main buses and one transfer bus scheme not using for 400kV switchyard
what is function of centrifugal switch in single phase induction motor..?
wish of these transformer uses oil?
for testing busbar (33kv) hi-pot .whether we can apply DC r not.and what is the test volt for that .explain
describe the Tranformer testing procedure