Answer / a.v.satyanarayana.

Coping in civil engg. constuction is the part of
structure/Masonarywall which is constructed on top of
Wingwalls,Returnwalls,Boundary walls etc to protect the
masonary aswell to drain off the rain water&improves
aesthtics of the structure/wall.

Answer / amar

Laying of concrete top of the wall to avoid the entry of
rain water in structure or wall

Answer / akhilesh

coping is made on the top of the waals to protect the wall
in the rainny season. It made on thetop and it carry the
slop from the centre in boyh side.

Answer / devendranchandrasekar

coping is a top member of the parapet wall it provide
neccessary slope 1:20 during rainy season water should drip
on the top to flow inside of the terrace and also do some
groove provide below coping .it should be provide lean
concrete and also reinforcement is needed
it should mainly take care of crack in the parapet wall
provide shear key also in the parapet wall

Answer / amol s. bidwai

Laying of concrete top of the brickwall to avoid the entry
of
rain water in structure or wall

Answer / vkadian

to avoid leakege of water in structure

Answer / vinod*sriharikota@klc

It is the thin layer , laid on the top of the walls in order to prevent entry of water in structure

Answer / syed mumtaz ali shah

Coping is a top member in low raise buildings & also
provides at any level of high raise buildings for good
look, to avoid rain inside & now a days some buildings
gives architectural view through the coping only.

Answer / jobin

Coping is raising of parapet wall of terrace in order to prevent leakages from terrace. It is done by providing slope so that rain water could pass away.Coping is provided by laying R.C.C over the present parapet wall.

Answer / baburajkumar

Coping is also used in Brick / RCC manhole construction work . it is binding structural portion with manhole cover frame portion and used material are cement concretr

In a beam tension is always at the bottom but sometimes when we design using staad we get more number of rebars at the top compression zone Why?

1 Answers  

calculate if the size of the beam is 300*500 then L for the top & bottom bar

2 Answers   ACPL,

convert 1cum how many kilo

7 Answers  

What is the difference between Design and nominal mix?

2 Answers   HHH,

Engineering method, why need is column kiker??? what is necessity??

1 Answers   BNF Group,

How much sand for a 1000 sqft residential building ?

1 Answers  

Which is the indian standard code of line out. ? How much tolerance fot 1 mt lenght? Its challenge....

0 Answers  

Form where IS456 is adopted in 1978?

0 Answers  

why do we provide haunches in rcc box or underpasses?

0 Answers  

How much permissible bearing capacity requires for open footings(isolated) and what type pile foundatuon prefering for coastal areas?

0 Answers  

how much volume is one bag cement of 50kg

15 Answers   Portland, RJB, UltraTech,

five requirements of infill panels for walls?

0 Answers