Answer / jyotirmaya

Thanx a lot for your reply.
Kindly post the minimum accepted IR value.

Answer / rajavelu

ir value test
33kv,66kv,220kv

Answer / yash

yes.megger test is prformed and IR value is almost 1G Ohm

Answer / amji r jadhav

the megger test ir is infnt 0 your ans but 33kv line charge in the stand by minimum 10mgo this is the megger value

Answer / krupa

Megger Test is applied on surge Arrestors and its accepted
IR Value is infinity

what is the effect of un-synchronized power.

0 Answers  

HOW TO MEASSURED THE AMPS RATING FOR SUITABLE CABLE SIZE?

4 Answers  

how to connect from a line-to-line connection to a line-to- neutral connection?

6 Answers  

in catridge heeter  watts =110, 260 v ,  i checked in multimeeter meeter shows 50 ohms but oms law r=v square /w  260*260=67600, and 67600/110=614.5 ohms  how to caluclate exact ohms in heetre s 

2 Answers  

why the desirable efficiency for a motor is 60%, but in case of transformer, it is above 90%?

1 Answers  

how does high earth to neutral voltage affects electronic circuit?

0 Answers  

what happen if the battery is charged by more than one source ,for ex: connecting data cable to laptop & charger pin to source supply ? 

2 Answers  

While testing a ZCT what parameters have to check or measure?

0 Answers   Indian Railways,

I want to ask a question which i faced during testing of Capacitive Voltage Transformer in AIS. We have measured the C1 , C2 individually , but when we start to measure the total C1+C2 , the testing equipment shuts down and says low loading. Kindly is it possible to find the total capacitance by using measuring device. kindly briefly explain the procedure.

0 Answers   AIS,

what is servo motor and how it works?

0 Answers   Godrej,

What do you mean by 4.44 in this transformer equetion E=4.44 nfqm

4 Answers   Bharat Bijlee,

What type of tranformer generaly at soft wares like capacity 2000 kva 1800 kva etc iam confused it CT or PT OR distribution tranformer

3 Answers