Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT ARE THE SITE TEST APPLIED ON A SURGE ARRESTORS? DO
MEGGER TEST APPLIED ON SURGE ARRESTOR? IF YES THEN WHAT ARE
THE ACCEPTED IR VALUE REQUIRED FOR SURGE ARRESTORS FOR
VOLTAGE LEVEL 11KV, 33KV, 66KV 132KV, 220KV AND 400KV?
- 5 Answers
- 11428 Views
- I also Faced
- E-Mail Answers
Answer Posted / jyotirmaya
Thanx a lot for your reply.
Kindly post the minimum accepted IR value.
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
for 11KV OH system what will be typical per KM "R" "L" "C" parameter. for 33KV OH system what will be typical per KM "R" "L" "C" parameter. for 33KV UG system what will be typical per KM "R" "L" "C" parameter.
In siemens S7-300 PLC, what is function and function block ? What is the difference between them ? When to use function and when to use function block ?
What should be the magnetic balance test values for a 3 phase delta/star connected single primary dual secondary winding transformer (90 MVA / 2 X 45 MVA TRANSFORMER)
how u measure/calculate renge of capacitor,capacitor has no any rating tag.what is the theory of measure of capacitons.
Is RTCC panel needs any control supply.
What is the effect on in Zone and out zone fault if Phase side CT is Vk/2<30 mA and Neutral side is CT is Vk/4<30 mA for Transformer REF protection
Suppose a 3 phase, 2 pole, 440V induction motor is driving a flywheel of 600mm diameter, 150kg mass. By using v-belt and pulley, the speed is increased to 4500 RPM. What will be the effect on motor current?
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
what is the star delta connetion and how can do it a three phase motor with control witing with picture
What is the name of the winding to which supply is given?
I want to know Electrical Circuit?
What is meant by analogous system?
advantages and disadvantages of inverse definite minimum time RELAY
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
Why should we hire you over the others waiting to be interview?
