Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT ARE THE SITE TEST APPLIED ON A SURGE ARRESTORS? DO
MEGGER TEST APPLIED ON SURGE ARRESTOR? IF YES THEN WHAT ARE
THE ACCEPTED IR VALUE REQUIRED FOR SURGE ARRESTORS FOR
VOLTAGE LEVEL 11KV, 33KV, 66KV 132KV, 220KV AND 400KV?
- 5 Answers
- 11423 Views
- I also Faced
- E-Mail Answers
Answer Posted / krupa
Megger Test is applied on surge Arrestors and its accepted
IR Value is infinity
| Is This Answer Correct ? | 5 Yes | 6 No |
Post New Answer View All Answers
what is the necessary of using inductance property in transmission lines even through resistance is used to opposes the high current flows in that?????
What are the applications of different multistage amplifiers?Plz also write advantages of these amplifiers? Thaaaaaaaaanx
how will we calculate the copper wire load..
What is warm / cold start of HT motors. How many warm start & cold start are possible in a day?
What is Primary And Secondary Injection Test of Relay and Other Electrical Devices. How IT is carried out.
how do prepare ongc exam.how is it question model.i am electrical. which part covering in electrical.tell me
how to apply b license to c license in tneb
How can we connect additional batteries to three phase ups? What are parameters we have to check when connecting?
how current is reverse from its normal direction during the fault?
what is the purpose of shading ring or shading coil in electrical equipments.
It is desired to flood light the front of a building 42 meters wide and 16 meters hig.Projectors of 30 degree beam spread and 1000 watt lamps giving 20 lumen/watt are availabl.If the desired level of illumination is 75 lumen/m and show a suitable scheme.Assume the cofficient of utilization, deprecitation factor and waste light factor are 0.4, 13 and 1.2 respectively.
Define resonant peak?
I want single line diagram for AMF & DG syncronizing panel
WILL SCHNEIDER MAKE ACB(MASTERPACT)TRIP ON REVERSE POWER?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
