WHY STABILIZER SHOULD USED
Answers were Sorted based on User's Feedback
Answer / rakesh
By the use of stabilizer we can stabilize input voltage
Is This Answer Correct ? | 2 Yes | 0 No |
E.B sending end to receiving end 33kv ug cable laid 8Km,receiving end to ss1,ss2,ss3,ss4 all are Approx 800 Mtr,can go for 33KV to 430V or 33kv to 11kv in receiving end and 11kv to 430 near ss ,which one is good for technically and economically.
Do you know how to measure the earth resistance?
difference between Ac and Dc mcb ????
Why 30°phase shift occur in star-delta transformer between primary and secondary?
What will be MF for below rating ? Main CT PT value is 11kva/110 and 20/5 amp Meter display is 1kva/110v and -/5 amp What will be MF ? Multiplycity factor of energy meter
How will you calaculate the Ct ratio based on connected load 500KVA,and 11KV supply ?
is it possible to start a motor in felid connected to a remote mcc
Why DC weldings sets preffered over AC considering human safety aspects ?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
in dc series motor if field wdg is shorted then
what happen if we supply 220v dc suppy to the bulb or tube
What is the lifetime of a Thyristor? Is there a recommended lifetime for thyristors after which they should be replaced?