WHEN BOTH WIRES OF THERMOCOUPLE R SHORTED WHAT IS THE OUTPUT THE TEMP ARE 0,3

WHEN BOTH WIRES OF THERMOCOUPLE R SHORTED WHAT IS THE OUTPUT

THE TEMP ARE 0,30,250,320

Question Posted / guest

13 Answers
22130 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

WHEN BOTH WIRES OF THERMOCOUPLE R SHORTED WHAT IS THE OUTPUT THE TEMP ARE 0,30,250,320..

Answer / jayakrishnan unnikrishnan

Question not clear...

Themocouple means "two dissimilar metal joined together at
one end" If again you want to short the other end also how
can you measure mv?
or how can you connect it to the terminals or measuring
device?
what will be the polarity.

Is This Answer Correct ?

0 Yes

0 No

WHEN BOTH WIRES OF THERMOCOUPLE R SHORTED WHAT IS THE OUTPUT THE TEMP ARE 0,30,250,320..

Answer / ravi

Generally thermocouples has two wires, this two wires are
positive and negative terminals. this two wires are used to
measure the voltage generated because of temperatures. If
this two wires are sort circuted, you cant measure the
output of thermocouple. ie you cant measure voltage with
two wires short circuted.

Is This Answer Correct ?

7 Yes

9 No

WHEN BOTH WIRES OF THERMOCOUPLE R SHORTED WHAT IS THE OUTPUT THE TEMP ARE 0,30,250,320..

Answer / kamalakannan

temp is zero once shortcicuit fuse will damaged so temp
showing is 0

Is This Answer Correct ?

1 Yes

5 No

Post New Answer

More Instrumentation Interview Questions

why are set -10vdc in bently neveda vibration system.

4 Answers

What is stripper & spilitter ? Diffrence in this.?

0 Answers JSW,

explain key exchanges in all security modes WPA,WPA2,TLS?

0 Answers

Please explain for RS 485 & RS 232 communication

1 Answers Honeywell,

what are the following documents comes under loopchecking

1 Answers Heisco,

can you provide me full detail about instrumentation in ONGC??

0 Answers BRML, ONGC,

why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.

0 Answers ONGC,

You are looking at the RS-485-side of an RS-232/RS-485 converter and the power supply voltage for the converter is +5V. Under idle conditions (no transmission), and assuming you have enabled the RS-485 output: what would you expect at: (a) Output A measured against output B (b) Output A measured against ground (c) Output B measured against ground

1 Answers EIT,

How to calibrate H2s Dectector

0 Answers KOC,

what is zero and span ?

0 Answers

what is the meaning of HART ?

2 Answers

why 4ma show higher zero ? i have transmiter flow renge 0-1000 m3/h but 4 ma show in monitoring 200 m3/h and 20 ma show 1000 m3/h i want when 4ma show 0 m3/h and 20ma 1000m3/h

3 Answers

For more Instrumentation Interview Questions Click Here