Answer / rajakumar k j

this check is preventive maintainance of DG sets(1000-1500KVA).
1) A-check is done on daily basis here we check:
a) oil level
b) coolant level
c) gauge valve level
d) check for any leakage.
e) cleanliness of DG set.
2) B-check(done after 300hrs of cycle or 6 months whichever is earlier. )
a) check lube oil filter
b) fuel filter
c) air filter
d) bypass filter
3) C-check(done after 1500hrs of cycle or 3yrs whichever is earlier.)
a) all steps of b-check.
b) check/change of air filter (if needed).
c) check/change of other filters mentioned in b-check.
d) change of gaskit of chambers.
4) D-check
a) done in 6000 hrs of cycle.

Answer / b.shekhar

B. CHECK 250 HRS OR 6 MONTHS
C. CHECK 1000 HRS OR 1 YEAR
D. CHECK 1500 HRS OR 2YEARS

Answer / o.ravindra reddy

A-Check Daily basic
B-Check 250-300hrs and 6months
c-Check 1500hrs and 1year
D-Check 6000hr cycle

Answer / p.murugan d.e.e.e, b.e(e.e.e)

RUNNING HOURS NOT REACHED DID NOT CONDUCT B,C,D,CHECK NO
PROBLEM. BUT DAILY CONDUCT A CHECK VERY VERY IMPORTANT
IMPORTANT PART OF THE DG SET 1.LUBRICATING SYSTEM, OIL LEVEL
2.BATTERY VOLTAGE, SPECIFIC GRAVITY,3.CONSERVATOR WATER
LEVEL,4.FUAL FILTER, WATER SEPERATER, ALL FUAL
TEMPERATURE,5.ANY LEAKAGE FROM ENGINE HOSE& PARTS 6.COOLING
SYSTEM &COOLING TOWER. THIS ALL CONDITION GOOD NOT CONDUCT
B,C,DCHECKS.

Answer / sharath patel

if the running hours not reached means we can conduct the
checks by the number of days from the comissioning date.

how we calculate the motor rating of pump for water suction ?its any formula for that plz give thank u

3 Answers  

what is the design factor that affects the size of a motor ?

3 Answers   Reliance, SGI,

What is the difference between DOL starter and star delta starter

0 Answers  

if suplly 11kva its give 440volts then if suplly is given 10kva whats the volts given

3 Answers  

Why arc quenching is used in Diode ?

0 Answers  

how we calculate torque ? how we improve it ?where torque will either motor or generator ?

0 Answers   Reliance,

how external lighting design? please give examples?

0 Answers  

Why is tan-delta test and capacitor measurement done on alternator?

0 Answers   TD Power Systems,

WHAT IS THE DIFFERNCE BETWEEN AIS AND GIS IN SWITCH GEAR?

5 Answers   L&T,

Why auxiliary transformers are not connected in parallel in primary stations?

0 Answers   Adweb,

what is the calculation formula for motor starting torque,running torque, running torque.

0 Answers  

WHY FEEDERS TRIP IN COLD AND FOGY WEATHER?

2 Answers