Answer / pundlik wanwe

Transformer properties are governed by the 2 Indian
Standards.1) IS 335 & 2)IS :1866
IS 335 is for new oil
IS 1866 is for oil in service
For the transformer in service as long as oil in
transformer is ok as per IS 1866 there is no requirment as
such for filteration of oil, but you have to follow the
manufactuer's instructions regarding this

Answer / geno peter

well , if the BDV is found ok, then not required to filter
the oil

Answer / ramjeet singh

Yes; at least once in a year it should be filtered and
tested as per IS 1866-2000 to withstand not only BDV,
moisture but all the 9 test parameters; as at least we
should know what has happened in terms of oil
characteristics within a year.

Answer / transformer oil filtration

<a href="http://oilfiltrationronyyee.blogspot.in/">Transformer oil filtration</a> :- We specialize in Transformer oil filtration & alternative oils filtration -recycling solutions for a global market. We also offer high-quality products for customers all around the world from different industries. =============

Answer / yokesh

at TNEB standards 40KV @1 min its a with stands the oil in
good condition. gap between two poles is2.5mm.

what is the similarity and difference between ups and inverter?

4 Answers   GMR,

In a tap changing transformer where is the tap connected, is it connected in the primary side or secondary side?

0 Answers  

list the advantages of RCCB over other circuit breakers?

0 Answers  

What will happen if the rotor circuit of a slipring I.M. is kept open & electric supply is given to its stator winding.

2 Answers  

why we setting 95 deg and 105 deg in wti and oti of distibution transformer ? give the reson for that ?

0 Answers  

PLEASE EXPLANE WHAT IS " MOSFET AC CONVERTER"? WHERE AND HOW IT IS USED?

2 Answers  

If any one's require of phoenix contact like( relay , termilnal block , surge protection device ) , product please contect me 09878206357 chetan verma

0 Answers  

What is the effect on in Zone and out zone fault if Phase side CT is Vk/2<30 mA and Neutral side is CT is Vk/4<30 mA for Transformer REF protection

0 Answers   ABB,

What is corona loss?

2 Answers   PWD,

Why we use RYB phase sequence?

3 Answers  

why a single phase motor of same rating takes more amps than the three phase motor? as single phase motor at 230v takes 5amp per HP while 3 p motor takes 2.5amp per hp at 230v.

1 Answers  

how we can calculate power factor without knowing current in 230v 100w load ?

10 Answers