Answer / syamkumar

DG synchronization panel is required to parelleling of 2 or 
more DG's it may be as per the load dependent .one DG will 
be ON as per the master and other will synch oce the 
Frequecy ,voltage matches with master DG .this is required 
to share the load. 

Answer / syamkumar

Dg Synchronization panel used to 2 or more dg sets.
because load sharing perposs.
first master dg start upto 70% load increased to another dg will start that time voltage,HZ,RPM its to match only two dgs syneh. 

What are the probable causes for failure of heating elements

4 Answers   BARC,

---

can we share mvar in parrelell connected alternators

2 Answers  

---

What is gain margin?

0 Answers  

---

how oil in the MOCB was reduced compared with OCB? what are the features of the MOCB?

0 Answers   Asahi, BARC, K-Electric,

---

To prevent the mal operation of a differentially connected relay while energizing a transformer, the relay restraining coil is baised with (a)second harmonic current (b)fifth harmonic current (c)third harmonic current (d)seventh harmonic current

2 Answers  

---

can we individually produce electriciyt

1 Answers  

---

How much load can be taken for chiller from 1500 kva transformer

0 Answers  

---

what is skin effect? why is it absentin dc system

22 Answers  

---

IF I KNOW THE AREA OF CROSS SECTION OFTHE WIRE , WATTAGE OF THE LOAD ,VOLTAGE SUPPLY WHAT IM GIVING TO THE LOAD AND ALSO POWER FACTOR OF LOAD ....... SO GIVE ME FOR WHAT AMOUNT OF CURRENT I SHOULD USE WHICH TYPE OF CABLE?

0 Answers  

---

How to calculate the Harmonics losses in terms of cost/unit.

0 Answers  

---

What is the purpose of Rotor earth fault relay and How to test the Rotor earth fault relay in generators and What is the procedure?.

1 Answers  

---

full form of flry b

0 Answers   KPIT,

---