can anibody tel me on what basis the transformer vector
groups are determined????
What are the different auxiliary protections of a transformer?
1.why we are using metal oxide gapless block in lightning arrester,2.What is minimum and maximum rating of metal oxide blocks using in india
What Is Connection APFC Panel In Compony.
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT SWITCH BOARD,MLDB,ACB,BUSBAR,ETC...?
why we get 2 differnet values for power factor in 2 watt meter method in 3 phase
what is the order of mgnetiation current in a current transformer of 1000A/1A ratio?
i have flexible wire. size of conductors is 0.190 mm & no.of conductors are 48. then size of wire comes 1.37 sqmm instead of 1.5 sqmm . the what is tolerance for this size.
I find that underground strip-armoiured,4core,LT PVC cables in an earthed power distribution sytem are occasionly found in charred condition-with no trace of it except ash. Is this because of no proper earth connection/continuity (giving rising to high armour resistance)in the joint enroute or because of insufficient capability (again due to high armour resistance)of cable-armour to carry fault current or due to neglected /unprotected overloading of the cable or due to high armour currents caused by power thefts where only phase(s) are unauthorisely tapped & at the point of poer consumption earth terminal is established by burring underground a not so good earthing rod (or using an underground water pipe for the purpose)
what is the calculation of power factor?
how much capacity(rating) of generator required to operate a load of 100kv.
What is the use of 1:1 isolation t/f in any circuit...?
what should be the resistance valve of healthy earth pit