Answer / amit upadhyay dscl

HT is high tention and specify range of it is 11kv

Answer / rk

11KV but below 33KV HT and 33KV and above EHT

Answer / kk_london

ht means high tension voltage, ht voltage starts from 6.6kv
onwards to 11kv, 33kv, 66kv, 110kv, 220kv and so on
generally ht are used in transmission and distribtuion in
order to reduce the power loss i.e. when you send power at
high voltages current will be of small proportion and hence
decreasing the size of conductors and also the supporting
structures required to hold the conductors need not too
strong so over all a great amount of cost reduction can be
done by sending power at very high voltages and other than
transmission and distributing section ht voltages are used
for motors of greater capacity around 220kw, 315kw, 900kw.
And same priciple applies to motor as well and more over if
you go for lt voltages for the above range of motors the
insulation required for the stator and armature will be
more because at starting the motor takes 6 to 7 times the
full load current of motor.

Answer / k.prakashchandra

As per IE rules HT means voltage above 650 V and not
exceeding 33KV

Answer / kevinjoh27@yahoo.com

it is the high tension power supply .the rating of ht is 11KV

diffrence between abcb and mocb

1 Answers   UltraTech,

why generation of electricity in low value voltage

3 Answers  

What r the specification furnishid in motor name plate?

5 Answers  

how can electricity is produced without water

6 Answers   Bescom,

What was the Dg set radiator and lube oil temperatures trip in ACB

0 Answers   Gland Pharma,

How I design capacitor bank for different load.7MW connected load.

3 Answers   Samtel,

why would the rotor rotate at sub synchronous speed against the direction of rotating flux when d rotor of 3 phase IM is connected to 3 phase balanced supply and the stator windings are shortcircuited ??

0 Answers  

how to calculate a cable size while load is given in amp or kw and length is also define.?

1 Answers  

Explain about retrofitting of machine tool.

0 Answers  

what is the relation between knowing of the distance between power transformer and the capacitor feeder in case of parallel operation

0 Answers  

why a bulb glow when connected with two end phase and neutral respectively.

1 Answers   ACME,

We know that, in case if there is a faulty insulation,or sc, the current is bypassed to earth through the earth wire that has low resistance.Actually, what will happen to that current that flows through gnd?In that case,if we come in contact with that faulty appliance, wont that current flow through us as we form a closed path by standing in gnd?Is grounding a safety measure?

3 Answers