Interested to Buy Any Domain ? << Click Here >> for more details...
To check the earth condition (In plug points); the voltage
between earth and Neutral is in below 5 volts. Is it
correct
- 6 Answers
- 9095 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Yes, this is right if earthing condition is good . than the
voltage b/t earth and nutral is less than 5 volt . in
moutain aria , it is about to less than 8 volt .
| Is This Answer Correct ? | 8 Yes | 2 No |
Answer / anil bhatia
the earth condition depend upon soil condition ,
automosphere condition ,life of earth pit and regularty of
filling water in earh pit chamber.
| Is This Answer Correct ? | 4 Yes | 0 No |
Answer / sanjiv
Earthing depend of area of humidity.Costa area 5volt is ok but dry area 8volt is ok.
| Is This Answer Correct ? | 2 Yes | 0 No |
Answer / amit upadhyay kheri
yes, it is true that the voltage b/w earth & neutral is 5 to
10 volt.
| Is This Answer Correct ? | 1 Yes | 7 No |
how will protect transformer agint overcurrent protection
how is the cable tray designed & how its total length is calculated for an Industrial plant Say for Ex. (500KW Motor Load)
in 3phase 50kva dg what is the full load current for single phase laod
Why we use auxillary relay ? what is function of differential relay, directional o/c relay?
0 Answers Century Rayon, Mechanical,
how can we measure the import power and export power in the same line?
Meggering minimum acceptable Ohms for insulation resistance.
Types of test in Switchgears, MCC, NGR and DB's how it should be procced. Can anyone give me the details here or email me to pasuvaraj.k@gmail.com
Dear all, is ther any body who can tell me about the setting of ACB(air circuit breaker ). what kind of it,s setting is and how to do it,s setting. also please tell me the setting of VCB(vaccume circuit breaker) . please tell me their setting,s. i will b very thank ful to all of u. Thank,s and Regard,s. Muhammed Ikram.
What is the difference between Contactor and Circuit breaker ?
What is milivolt dop test in Busducts? What is its significance & procedure to do the test?
why we use to transmit the power in three phases intead of single phase ?
How Load Factor, Demand Factor, Diversity Factor etc best applied in designing an electrical circuit? Is it allowed to consider these factors in each and every panel in an electrical distribution system? Can any body suggest a good book for reference?
-
Civil Engineering (5086) - Mechanical Engineering (4456)
- Electrical Engineering (16639)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
